Looking On The Bright Side of Metals

What You Can Learn From Clad Metals

To attain the best results of the metals that you will be using for whatever purpose you have in mind, two distinct alloys or metals must be bonded into one and the result is what you call the clad metals. There are different forms of clad metals that you can make the most of such as sheet, wire, rod, plate, and tube forms. The alloys and metals that come common for engineering use are those that allow you to easily clad them together. If you are looking for specific characteristics from your composite materials, then cladding is the best process to use to get the kind of characteristics that you need from them that you cannot get in just one material.

Heavy electroplating, heavy chemical deposition, co-rolling, casting, diffusion bonding, co-rolling, and co-extrusion are just some of the examples of processes that help in the bonding of clad metals. The use of clad metals among jewelry has combined the use of low-cost base metals from the beauty of precious metals.

There are basically two kinds of clad metals out there, the overlay clads and the inlay clads.

Inlay clads can give you sophisticated looking clad metals that you have never seen before. Using an inlay, the designer will then combine cheaper materials such as copper, stainless steel, and brass with more expensive materials such as palladium, gold, silver, and platinum. This is the best method of getting a better appreciation with precious metals on your materials all the while getting some properties that will work well as spring, welding, and heat sinking can result to.

Going with inlay cladding has been shown to be more beneficial than the use of selective plating. It is only with the process of inlay cladding that utilization of wrought alloy is made possible. This can help in achieving a more consistent composition while the use of other alloys that cannot be plated before can just be plated. By opting for better materials for inlay cladding, there is no doubt that your materials will turn out more dense, more wear resistant, and much harder in comparison to the plated surfaces.

The bonding of different layers of metals together is made possible with overlay cladding. The use of filler materials or adhesives is not done with this particular method of bonding metals or alloys. If the both of these materials are used, bonding can still be attained with extreme heat or pressure. The end results can go as many as seven layers to three layer and two layers. What is great about overlay clads is that if you have certain requirements with your clad metals, you can specify what your industry needs of them. To learn more about clad metals, make sure to check here!

The Art of Mastering Services

3 Lessons Learned: Materials